CS

Options & Accessories

Filter Products expand_more expand_less

Reset Filters

Measurand

Frequency Rangeexpand_morechevron_right

Hz
Hz
chevron_right

Weightexpand_morechevron_right

g
g
chevron_right

Accelerationexpand_morechevron_right

m/s²
m/s²
chevron_right

Powerexpand_morechevron_right

N
N
chevron_right

PR-Measurement

PR-Measurement

Signal conditioners and software for PR-sensors

PR signal conditioner power supply of piezo-resistive (bridge), variable capacitance and similar sensors used with the CS18 calibration system

for the calibration of piezo-resistive sensors

chevron_right

Laser vibrometers

Laser vibrometers

Calibration of laser vibrometers

Optical components and software for calibration according to ISO 16063-41

Optical components and software for calibration

chevron_right

SUPPLY internal

SUPPLY internal

Provides proper connection of several kinds of sensors to a voltage input of a measurement device (here: CS18 VCU). Sensor is plugged in at input. Signal output is connected to CS18 VCU input. Provides DC supply voltage(s) for sensor and performs signal preconditioning.

Signal conditioners

chevron_right

TRANS

TRANS

TRANS for CS18 VLF (primary and secondary)

Used for hardware and software to determine the cross-sensitivity of sensors

cross-sensitivity of sensors

chevron_right

Accessories Case ZK-STD

Accessories Case ZK-STD

For the effective calibration of accelerometers in the laboratory, it is necessary to have an assortment of standard accessories. This assortment is supplied with the accessories case CS18 ZK.

for Vibration Calibration Systems

chevron_right

Accessories Case ZK-HOP

Accessories Case ZK-HOP

For the effective calibration of shock sensors, it is necessary to have an assortment of standard accessories. This assortment will be supplied with the accessories case CS18 ZK-HOP.

for Hopkinson bar

chevron_right

APS 0109

APS 0109

The APS 0109 automatically controls the zero position of a vibration exciter irrespective of its load. It is essential to employ a position controller of type APS 0109 especially when working with an air-bearing vibration shaker without any integrated automatic load-compensation.

Zero Position Controller

chevron_right

ATS-15

ATS-15

Part of electrical final test and calibration bench

Attenuation Standard

chevron_right

CAL-Q-U-ICP

CAL-Q-U-ICP

Calibration of signal conditioners (payload-, IEPE-, measuring amplifiers)

In conjunction with the optional extra PHASE also applicable to PHASE calibration of signal conditioners

for signal conditioner

chevron_right

In its standard configuration, every CS18 calibration system is optimized for a specific practical application. Its performance, however, can be extended by means of optional extras. On customer's demand, dedicated options can be compiled and offered with the system.