DT
SE-11
The SE-11 high frequency vibration exciter was developed especially for the characterization of sensors, MEMS and small components. Due to the design of the armature the DUT can be excited with nearly no cross motion in the frequency range 2 kHz ... 50 kHz.
Downloads:
- force, max.: 100 N
- displacement, max.: 30 μm (peak-peak)
- useable frequency range: 2 kHz… 50 kHz
- resonance frequency: >52 kHz
- ceramic armature with coupling surfaces on the side (30 mm × 30 mm)
- high acceleration amplitude up to 400 m/s²
- very low cross motion typical < 10 %
- extreme wear resistant ceramic armature
- internal high frequency reference accelerometer
For detailed information see current data sheet. Subject to change without notice.
Similar Products:
APS 113-AB
APS 113-AB
Air-bearing ELECTRO-SEIS® Long Stroke vibration exciter, especially developed for the calibration and testing for low frequency sensors and sensor charcterization.
chevron_right
SE-13
SE-13
Air-bearing electrodynamic Vibration Exciter with mounting table for high payloads up to 50 kg. Especially developed for seismic simulation of components,
primary and secondary calibration as well as testing of big and heavy low frequency seismic sensors or geophones.
chevron_right
SE-09
SE-09
The air-bearing SE-09 high-frequency vibration exciter is a high-tech product developed especially for the high demands of calibration laboratories and metrology institutes as well as for characterization of MEMS sensors.
chevron_right
APS 129
APS 129
Air-bearing ELECTRO-SEIS® Long Stroke Vibration Exciter with mounting table for high payloads up to 23 kg. Especially developed for the calibration and testing of big and heavy low frequency sensors as well as for sensor characterization (e.g. geophones or heavy seismic sensors).
chevron_right