DT
SE-16
Rugged vibration exciter that has been specially developed for high frequency excitation of small components and sensors both in the longitudinal and transverse direction. Devices Under Test (DUT) can be glued to the top or sides of the technical ceramic armature in any orientation to the main vibration axis.
Downloads:
- Acceleration, max.: 400 m/s²
- Force, max.: 12 N
- Frequency range: 5 kHz…100 kHz (200 kHz)
- Payload, max.: 5 g
- rugged ceramic armature 15 mm × 15 mm (0.6 in × 0.6 in)
- mounting surfaces on the top and sides
- very high first axial resonance frequency: > 110 kHz
- low transverse motion: typically < 10 %
For further details, please refer to the technical data sheet. Subject to change without notice.
Similar Products:
SE-11
SE-11
The SE-11 high frequency vibration exciter was developed especially for the characterization of sensors, MEMS and small components. Due to the design of the armature the DUT can be excited with nearly no cross motion in the frequency range 2 kHz ... 50 kHz.
chevron_right
SE-13
SE-13
Air-bearing electrodynamic Vibration Exciter with mounting table for high payloads up to 50 kg. Especially developed for seismic simulation of components,
primary and secondary calibration as well as testing of big and heavy low frequency seismic sensors or geophones.
chevron_right
SE-09
SE-09
The air-bearing SE-09 high-frequency vibration exciter is a high-tech product developed especially for the high demands of calibration laboratories and metrology institutes as well as for characterization of MEMS sensors.
chevron_right
APS 113-AB
APS 113-AB
Air-bearing ELECTRO-SEIS® Long Stroke vibration exciter, especially developed for the calibration and testing for low frequency sensors and sensor charcterization.
chevron_right